good compression for engine?
#1
Rotary Enthusiast
Thread Starter
iTrader: (5)
Join Date: Apr 2006
Location: pennsylvania
Posts: 1,488
Likes: 0
Received 0 Likes
on
0 Posts
good compression for engine?
what is good compression for engine? I think I found an rx7 for myself to buy, im taking it to a dealer to be looked over and compression checked. What are some good numebrs i should be looking for? 13b btw. 93 fd
#3
Lives on the Forum
Join Date: Dec 2001
Location: San Lorenzo, California
Posts: 14,716
Likes: 0
Received 8 Likes
on
8 Posts
From the FAQ:
28) What should the compression be?
Compression test results are reported as six numbers: 3 per rotor. (This is not the same as the compression ratio). Higher, more equal numbers are best. The original Mazda specs dictate 8.5+ kg/cm² as new (121+ psi), with 6.0 kg/cm² (85 psi, 690kpa) being minimum acceptable. Maximum difference should be 1.5 kg/cm² (21 psi, 150kPa) from the highest to lowest value. It is important this test is carried out using proper equipment and under the correct conditions for rpm and engine temperature. Mazda dealers are generally reliable for performing this test, so long as they follow the procedures precisely.
28) What should the compression be?
Compression test results are reported as six numbers: 3 per rotor. (This is not the same as the compression ratio). Higher, more equal numbers are best. The original Mazda specs dictate 8.5+ kg/cm² as new (121+ psi), with 6.0 kg/cm² (85 psi, 690kpa) being minimum acceptable. Maximum difference should be 1.5 kg/cm² (21 psi, 150kPa) from the highest to lowest value. It is important this test is carried out using proper equipment and under the correct conditions for rpm and engine temperature. Mazda dealers are generally reliable for performing this test, so long as they follow the procedures precisely.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM