full non seq question. (searched)
Thread Starter
Joined: Feb 2003
Posts: 1,946
Likes: 1
From: Bellingham Wa
full non seq question. (searched)
Do i have to get the flapper thing welded to do full non-seq? i want to do it all but the welding part. is it possible to get rid of most of the rats nest. without haveing the flapper welded?
Last edited by RX7WEEE; Sep 10, 2004 at 08:14 PM.
Senior Member
Joined: Apr 2001
Posts: 454
Likes: 0
From: salt lake, utah, usa
if you're just worried about not doing it right away then you can wire it open, but you need to go get it welded open asap. and you do mean the one in the turbo housing, not the exh. manifold right?
Thread Starter
Joined: Feb 2003
Posts: 1,946
Likes: 1
From: Bellingham Wa
i just want it as a tempaory one because the turbos have alo of miles on them all ready, so ill do all that stuff while the engine is out, and after the brek in ill swap my new 23k mile turbos on it, thanks 
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
Oct 9, 2015 10:05 PM
rx8volks
Canadian Forum
0
Sep 1, 2015 11:02 PM