Fuel Rails for 1600cc inj's.
#1
Senior Member
Thread Starter
Fuel Rails for 1600cc inj's.
After hearing a few horror stories about the unreliabilty of 1300cc inj's I'm thinking about just going the 1600cc route. I've been told by a few people that the rail K2RD sells is pretty good. My only concern is the AN fittings. I really don't want to replumb my entire fuel system. Is there an AN adaptor that would mate to the stock fuel lines? Also does the stock FPD work with this setup? What about the pressure regulator? TIA.
PS - I have the RX7.com upgraded fuel pump (pretty sure it's the Cosmo/Supra/Nippon), would this supply enough pressure for 1600cc inj's?
PS - I have the RX7.com upgraded fuel pump (pretty sure it's the Cosmo/Supra/Nippon), would this supply enough pressure for 1600cc inj's?
Last edited by jr; 12-22-02 at 11:54 PM.
#6
Lives on the Forum
JR PM me wiht any questions about AN fittings...
these are the rails i have made. (the toes in the pic are bacon's) mine is the one on the right
this is the primary rail.
these are the rails i have made. (the toes in the pic are bacon's) mine is the one on the right
this is the primary rail.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post