Few Quick Questions about IC Sprayers
#1
development
Thread Starter
Few Quick Questions about IC Sprayers
Got no love in the other section...I know people will at least see it over here.
TIA.
https://www.rx7club.com/showthread.p...hreadid=259762
TIA.
https://www.rx7club.com/showthread.p...hreadid=259762
#3
Newbie
Join Date: May 2002
Location: Dallas
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Hey, I'm doing the same here.
I will use rubbing alcohol, since its free for me at the office.
I will be diluting it to 50% or less.
Reason??
Alcohol will evaporate at room temp fairly quick, so in order to hit the IC before it evaporates, you might want to lower the concentration.
Alcohol also attacks rubber, another reason to dilute it.
What did you use as pump???
How do you activate it with a manual switch or the wipers switch???
I will use rubbing alcohol, since its free for me at the office.
I will be diluting it to 50% or less.
Reason??
Alcohol will evaporate at room temp fairly quick, so in order to hit the IC before it evaporates, you might want to lower the concentration.
Alcohol also attacks rubber, another reason to dilute it.
What did you use as pump???
How do you activate it with a manual switch or the wipers switch???
#4
development
Thread Starter
I installed a rear wiper reservoir...
manual momentary push button switch, I'm installing it under the blank center switch in the console, so it won't be an eyesore. I'm hoping to use the blank cap as the top of the switch.
Thanks for clearing that up for me.
manual momentary push button switch, I'm installing it under the blank center switch in the console, so it won't be an eyesore. I'm hoping to use the blank cap as the top of the switch.
Thanks for clearing that up for me.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM