silvr94r2

iTrader: (3)

See how these come through.......1st one is when I brought it home.

silvr94r2

iTrader: (3)

this one is after I took it back apart with my fingers (bolts were only hand tight ) I'm gonna redo everything and change a bunch of stuff.

Here I'm mocking up the new fuel system.....changing all the lines from front to back and putting the new SX filter right here to make it easier to change.

silvr94r2

iTrader: (3)

my unfinished UIM...still got a "few" things to do...my lower will look much better than this When there done they will be fully polished.

legendr35

looks cool dude, what kinda turbo is that?

silvr94r2

iTrader: (3)

Greddy T88.....I'm gonna take it apart and polish the compressor side so it'll match the other stuff.

silvr94r2

iTrader: (3)

Here's my RC bored throttle body which I still need to port match with the intake.

rx7mania

how much hp did you get from greedy t88 ?

twinturboteddy

I like the polished engine bay =D

silvr94r2

iTrader: (3)

The engine will look much better here in a couple weeks after I get the rest of the stuff finished with grinding and sanding and doing all the mods. I'm changing alot of stuff around.....and i'm also polishing or chroming a few more things. I've got a few clean-up tricks up my sleeve that i'll have done also.

I haven't got the car running yet with the T88....it's never been close enough. I mean, soon as I got it back the 1st time I took it back apart.....then I just got it back again, now I'm gonna start all over and do all the stuff that I've wanted to do from the start. I'm not gonna make this season so I'm just going ***** out now! Dogbox.....all new custom suspension.....body reinforcements....the works!!!!!

I'm not even bringing it to a race unless it's running low 10's....then with a little tuning and driving i'm gunning for low to mid 9's.

silvr94r2

iTrader: (3)

TTTeddy: thanx.....i'm getting better at polishing....not as good as you yet, but it'll look good none the less I'm not looking forward to the LIM...it seems like it's gonna be a little pain in the ***!

95R2-89TII Ground Zero

I'll agree with that. I just finished polishing my Intake and it was a total piece of ***.

RavenRx7

How long does it take to polish something like that??

silvr94r2

iTrader: (3)

I've got about 4hrs. into mine right now but that's with a bunch of grinding and welding. If you have the right tools but haven't really done it before then look to spend at least 4-5hrs on it. I'm extremely picky so i'm doing alot of different stuff that most people wouldn't do because you'll never see it....but I know it's there.

Jeesh! I just got done ordering a bunch of Earl's fittings and fuel line and all kinds of really odd ball things i don't really need but had to have and OUCHY! Can we say $500.....and that's my price.....it would be about $750 if i just called up out of the blue. Another $150 in 6061 alum. u-bends and piping It's gonna be worth it! It just makes me wanna go down stairs and start working on it again.....must sleep....can't even think.....sleep good!