3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

engine,trouble starting,fd...help

Thread Tools
 
Search this Thread
 
Old Jun 26, 2009 | 08:22 PM
  #1  
90rx7newbie's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Jun 2006
Posts: 38
Likes: 0
From: edmonton,alberta
engine,trouble starting,fd...help

o.k. its a 93 fd rhd,5spd. i put rebuilt engine in my car.everything went in fine.now when i start it,it just rolls over,its got good compression,spark,fuel.but when i pull the spark plugs out,suspecting them to be flooded with fuel.they are dry,no gas smell,but everything has been change from my other running rx7,coils,crank sensor,fuel pump,relays,injectors,everything that i can think off.
its like the injectors aren't opening and letting fuel in??any suggestions would definintley be helpful
Reply
Old Jun 28, 2009 | 08:02 PM
  #2  
93_jdm_fd's Avatar
Full Member
Tenured Member 05 Years
iTrader: (1)
 
Joined: Nov 2008
Posts: 83
Likes: 0
From: edmonton,alberta
any ideas?
Reply
Old Jun 28, 2009 | 08:11 PM
  #3  
Mahjik's Avatar
Mr. Links
Tenured Member 20 Years
iTrader: (1)
 
Joined: Aug 2001
Posts: 27,595
Likes: 43
From: Kansas City, MO
Have you verified that you have the fuel lines hooked up properly? Did you prime the fuel system and make sure everything was working? Also, check to see if your injectors are clicking by putting power directly to them.
Reply
Old Jun 28, 2009 | 08:16 PM
  #4  
racex7's Avatar
Enthusiast
Tenured Member: 20 Years
Liked
iTrader: (2)
 
Joined: Oct 2003
Posts: 143
Likes: 1
From: upstate NY
?

You should not have to prime any electric fuel pump besides turning the key on and off a few times to get fuel to the rail I would be more worried about the fuel pressure being to low then I would check that as well as the Injector OHMS check to see if there in spec forgot to tell you go to your local parts store and by a noid light set make sure you have injector pulse!

Last edited by racex7; Jun 28, 2009 at 08:19 PM. Reason: more info
Reply
Old Jun 28, 2009 | 08:33 PM
  #5  
alexdimen's Avatar
TANSTAFL
Tenured Member 15 Years
iTrader: (13)
 
Joined: Oct 2003
Posts: 3,770
Likes: 128
From: Richmond, Va.
I'd check to see if the lines are mixed up too. If they aren't since it's such a pain to pull off the intake see if it fires when you spray starting fluid past the TB. Then you know it's fuel related.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
Kyo
2nd Generation Specific (1986-1992)
6
Apr 13, 2019 09:24 AM
Junkee
New Member RX-7 Technical
2
Aug 15, 2015 01:57 PM
Marty RE
New Member RX-7 Technical
0
Aug 13, 2015 11:19 AM




All times are GMT -5. The time now is 12:57 AM.