I have removed my engine and tranny, but I am having a problem separating the two they seem to be stuck even w/ an inch of space all the way around .
Suggestions please??????

 

Did you separate the throw-out bearing from the collar?

 

the clutch is holding the 2 together. you must disengage the t-o bearing or just unbolt the preasure plate one bolt at a time rotating the flywheel to get to the next bolt. i hhave my engine on a stand at this time doing a swap . good luck...

 

if you haev released, just pull harder, it takes a good tug to get them apart.