engine mount dimension?
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: May 2009
Location: greece
Posts: 419
Likes: 0
Received 0 Likes
on
0 Posts
engine mount dimension?
hi,
i am fabricating my own poly mounts and i woyld like to know what is the height of the original mazdas mount to duplicate it.
my own are used and i am afraid to count on these.
can someone please help?
thanks in advance!
i am fabricating my own poly mounts and i woyld like to know what is the height of the original mazdas mount to duplicate it.
my own are used and i am afraid to count on these.
can someone please help?
thanks in advance!
#4
Registered User
iTrader: (8)
Every manufacturer is going to be slightly different due to decisions that they made based on durometer, costs, intended use and other factors.
The height is fairly tolerant and diameter is going to effect comfort more then anything else. Use your best judgment and you should be fine.
The height is fairly tolerant and diameter is going to effect comfort more then anything else. Use your best judgment and you should be fine.
#5
Senior Member
Thread Starter
iTrader: (1)
Join Date: May 2009
Location: greece
Posts: 419
Likes: 0
Received 0 Likes
on
0 Posts
level Zero,
i will use 90A durometer 3" diameter bar AND 1.5" diameter ,1" long piece at the top of the steel mount so the stell mount will be between the 3" and 1.5" pieces . the bolt will go throu the:
1)small piece
2)engine mont
3)large piece
4)subframe.
i hope to minimize noise that way.
thanks!!
i will use 90A durometer 3" diameter bar AND 1.5" diameter ,1" long piece at the top of the steel mount so the stell mount will be between the 3" and 1.5" pieces . the bolt will go throu the:
1)small piece
2)engine mont
3)large piece
4)subframe.
i hope to minimize noise that way.
thanks!!
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM