Engine ground placment?
#1
I Sold My Car 2 the Devil
Thread Starter
Join Date: Oct 2001
Location: Duncanville, Tx
Posts: 2,361
Likes: 0
Received 0 Likes
on
0 Posts
Engine ground placment?
I'm going to hook up some extra nice fat ground wires off my engine just because. I'm looking for some ideas on where to hook them up I already have an idea but 2nd opinions are always nice so let me know.
Thanks
Ryker
P.S. what gauge of wire should I use?
Thanks
Ryker
P.S. what gauge of wire should I use?
#4
Bigger and better things
I went to Napa. They have a negative terminal with a 18" wire from it.. They say cut the old one and attach the one end of the new one to the batter and the otehr to the chassis.. Works very nicely.. Doesnt hesitate @ all! But then again it didnt do it often before .. ( maybe once or twice during 18 months)
#5
Senior Member
Join Date: Jan 2002
Location: blah
Posts: 733
Likes: 0
Received 0 Likes
on
0 Posts
ground
Originally posted by Dont_Be_A_Rikki
I used a ground strp from auto zone nice and big for like 3 bucks from the motor to the firewall (replaced that shitty stock one)
I used a ground strp from auto zone nice and big for like 3 bucks from the motor to the firewall (replaced that shitty stock one)
#6
Senior Member
Join Date: Mar 2001
Location: winston-salem, nc
Posts: 712
Likes: 0
Received 0 Likes
on
0 Posts
the thicker, the better.
do one from the block to the frame (under the rear plugs is a good attach hole for the block).
one from the neg. terminal to the chassis.
one from the firewall , pax side, to the back side of the UIM.
one from the junction of the cat and exhaust to the body.
do one from the block to the frame (under the rear plugs is a good attach hole for the block).
one from the neg. terminal to the chassis.
one from the firewall , pax side, to the back side of the UIM.
one from the junction of the cat and exhaust to the body.
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
befarrer
Microtech
3
08-22-15 05:52 PM