Hey guys,

I got one thing left to fix on my FD before it is roadworthy.

For some reason non of the turnsignals work. If I use the indicator stick to indicate a lane change the click sound is there but none of the turnsignals front, rear or even the turn signal lamps in the dash work.

Also, if I use the hazard button there is no audio and nothing turns on.

I have checked the bottom the fuses in the fusebox in the drivers side footwell as the names of the fuses for the bottom ones had been rubbed off. So I couldn't see if one of them was related. I could not see a fuse that was broken.

Any help would be much appreciated,

Thanks
Alex

 

 

So from what I can read Carson I need to check my #12 and #1. Also I need to check the 15A fuse?

I am really not good with these electrical diagrams.

I see the "In heater control unit" could removing my AC have anything to do with my problems? (I know it seems like could my weight be affecting my tail lamps kinda thing)

Thanks for the help,

Alex

 

you weren't kidding I can't even see where your chose #12 and #1
since you say your hazards aren't working.

Start with #2 15A Hazard...it powers the flasher unit.

Then check #9 15A Meter...it gives power to your turn switch.

Did you remove the heater control unit?

Note: Hazards should work with the car off, and turns only work with ignition ON.

You can check the BTN 60A fuse under the hood, but I think more would be wrong with your car than just signals.

 

Download factory electric manual. There is step-by-steps troubleshooting guides for turn signal. With symptomps and solutions. Much easier that way..

 

I didn't remove anything. In removing the AC I removed all the components in the engine bay and left it to the parts that stick out of the firewall there.

I will check those fuses.

Honestly everything else, the cluster illumination, the brake lamps, the headlights everything *knock on wood* works good. The only other thing I have noticed is it takes a long time for the power windows to go down and up.