Hi guys.

I've connected my ECU back to the harness and there are some wires that have been cut and spliced into.

A green and red wire cut to remove the 180km/h JDM speed limiter but has a 3 way connector with a white wire not connected from the ECU side. (1M - vehicle speed sensor)

A pink wire with a 3 way connecter spliced into it with a black wire not connected to anything. (according to the manual the pink wire is supposed to be blue) (1U - fuel thermo sensor)

A brown and black wire with a 3 way connector spliced into it but no third wire. (4D - Ground input)

There is also a black wire going from 1S (stoplight switch) to 1P which is supposed to be empty. The original green wire that's supposed to be in 1S is not there.

There is also an orange and black wire connected to 1V and according to the manual no wire is supposed to be there.

http://i1060.photobucket.com/albums/...psqsnatp35.jpg
http://i1060.photobucket.com/albums/...psqahmkggt.jpg
http://i1060.photobucket.com/albums/...psb0uyiz0a.jpg
http://i1060.photobucket.com/albums/...ps2ksyg9my.png

Are all these wire involve with each other? What can I do with these wires? Any help would be much appreciated! Thanks