easy injector removal
#1
Constant threat
Thread Starter
easy injector removal
After fighting with my injectors for a couple of hours and not wanting to break any of the plastic, I investigated new ways to approach the problem. I found that a standard 1/4" air fitting has an ideal size and shape that allows you to put it against the actual injector base without fear of damage and use it to drive out the injector from the rail. I carefully put the tip that is the coupler side of the fitting against the injector with the rail mounted in a vise and with a gentle whack against it using a small mallet it just popped that injector right out!
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM