I just replaced my clutch with a 6 puck not to long ago and while replacing it i dident push the fork in on thepressure plate. i kept pumping the clutch peddle til the slave cylinder shot fluid out =/... i put the fork on right and bled slave cyl. What do i do now?!? do i have to bleed the hole brake system to get rid of that light?!?

 

Check here for some suggestions:
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/parking-brake-light-stays-how-tighten-handle-39072/

 

Check you break fluid level. It dosent take much for the fluid to gown before the senson is activated.

 

sorry cant read.

 

my bad i was half asleep when i wrote the post =/ i was just wondering what triggers the e-break light?!?

 

fluid level, if it's low it sets off the light. your brake and clutch fluid are the same resovour

 

Read the link I provided above.

 

brake