from double din to STOCK radio
#1
from double din to STOCK radio
was wondering has any one went from a double din back to the stock radio ? or single deck with OEM pocket?
i ask because my FD has got a full double din for about 10 years now and of course the middle separator had been cut for the double din to fit.
now that i feel the double din thing is played out and like to return back to stock or just a more simpler setup like a single deck. however, with out the middle bar is it possible to do so ?
i ask because my FD has got a full double din for about 10 years now and of course the middle separator had been cut for the double din to fit.
now that i feel the double din thing is played out and like to return back to stock or just a more simpler setup like a single deck. however, with out the middle bar is it possible to do so ?
#2
RX-7 Bad Ass
iTrader: (55)
I think it will all go in there fine without the middle separator. There are clips on the left and right sides of the pockets and stock stereo that hold the component in place.
I believe that separator is just cosmetic.
Dale
I believe that separator is just cosmetic.
Dale
#3
rotorhead
iTrader: (3)
This probably doesn't cover this exact detail of converting back to single DIN, but I went from a single DIN aftermarket unit to a stock unit after getting it restored. See this thread. https://www.rx7club.com/interior-ext...-bose-1112087/
Thread
Thread Starter
Forum
Replies
Last Post
85RX7GS
1st Generation Specific (1979-1985)
35
03-10-02 12:31 AM
t_mak@mail.plymouth.edu
Interior / Exterior / Audio
1
08-12-01 10:26 PM