Doing poor man NON SEQ mod right now and have question about pre-control!?!?
Thread Starter
Senior Member
Joined: Jul 2001
Posts: 596
Likes: 0
From: Columbus, Ohio
Doing poor man NON SEQ mod right now and have question about pre-control!?!?
I've pulled the TCA off and wired the door open, now aI came to the part with the pre-control and wastegate solenoids.
I have a PowerFC and I am wondering, do I switch the lines? Or do I just switch the wastegate line and plug the other?
I have a PowerFC and I am wondering, do I switch the lines? Or do I just switch the wastegate line and plug the other?
Senior Member
Joined: Jun 2001
Posts: 362
Likes: 0
From: marietta GA
http://www.rx7turboturbo.com/robrobi...other.htm#Poor Man’s Non-Sequential Turbo Mod
not sure if you saw, that, hope it helps, scott
not sure if you saw, that, hope it helps, scott
Thread Starter
Senior Member
Joined: Jul 2001
Posts: 596
Likes: 0
From: Columbus, Ohio
Yeah..I have that site....
Okay, tell me if this is correct:
Pulled TCA
Wired door open
Switched wastegate and precontrol vacuum lines
Pulled charge relief
Pulled charge control
Set PowerFC to non-sequential....
Did I miss anything?
Okay, tell me if this is correct:
Pulled TCA
Wired door open
Switched wastegate and precontrol vacuum lines
Pulled charge relief
Pulled charge control
Set PowerFC to non-sequential....
Did I miss anything?
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
Mar 28, 2017 03:30 PM
msilvia
3rd Generation Specific (1993-2002)
28
Apr 14, 2016 12:58 PM
