Does Greddy Mspec FMIC fit w/Apexi intakes?
11-01-07, 05:17 PM
#1
Does Greddy Mspec FMIC fit w/Apexi intakes?
I was looking at the instructions and it showed a pic of the piping. it looks like it might not fit but im not sure. does anyone have this current setup or has a pic of it? already searched. thank you.
Oun
Oun
11-01-07, 05:28 PM
#3
the mspec is an FMIC.
I think you'll need to move the intakes around a bit, but it should fit. here's a pic of my engine bay with one of the Greddy FMIC(noone knows if it's the mspec or vspec, but the ic piping is similar on both), but without my intake installed. It looks like there'd be plenty of room for the Apexi intakes.
I think you'll need to move the intakes around a bit, but it should fit. here's a pic of my engine bay with one of the Greddy FMIC(noone knows if it's the mspec or vspec, but the ic piping is similar on both), but without my intake installed. It looks like there'd be plenty of room for the Apexi intakes.
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM
