Dip stick mix up????
04-02-05, 05:08 PM
#1
Dip stick mix up????
Dumb question, but i just want to make sure.
I have too many rotary parts laying around and wondering if which is the 3rd gen dip stick.
these are the 2 different kinds i have:
1) pretty flexable, with a 45 degree bend at the tip ( i think this is 3rd gen)
2) pretty stiff, and straight all the way down, no bend at tip (2nd gen)
Is this correct? or is 3rd gen same as 2nd? i dont think so because it so hard to bend under elbow.
Thanks
I have too many rotary parts laying around and wondering if which is the 3rd gen dip stick.
these are the 2 different kinds i have:
1) pretty flexable, with a 45 degree bend at the tip ( i think this is 3rd gen)
2) pretty stiff, and straight all the way down, no bend at tip (2nd gen)
Is this correct? or is 3rd gen same as 2nd? i dont think so because it so hard to bend under elbow.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
BLUE TII
Single Turbo RX-7's
10
09-26-15 10:12 PM