Damn shift knob!
#1
Rotary Enthusiast
Thread Starter
Join Date: Aug 2003
Location: Rpv, CA.
Posts: 798
Likes: 0
Received 0 Likes
on
0 Posts
Damn shift ****!
ok, well I was sitting in the parking lot at crossroads trying to install my new momo shift ****. You know, you'd assume it would be pretty easy and only take a couple of minutes but omg...... took me 1 hr and 30 min!!! once I got the **** on, i needed to align it using 3 small hex taps then screw on the bottom portion... well lets just say those 3 taps were a pain in the *** to try to line up with the bottom portion so it could be screwed on........... but I finally got it on and I am very pleased and happy with the results.
Thread
Thread Starter
Forum
Replies
Last Post
distr0
Canadian Forum
3
10-07-15 08:17 AM