My crank angle sensor plugs and wires were extremely brittle and both managed to snap into several pieces today.

Anybody know where I could purchase just the two plugs and rewire them?

This is the only thing holding up starting up my new rebuild.

Thanks, Josh

 

Post in the classified section, or I think you could source them from Japan2LA or maybe Fritz.
Also don't forget to peel back the first layer as it is a coaxial cable, good luck.

 

Thanks. Will do.

 

I cut mine off and just used standard connectors to hook it up... been working for a while now.

 

You can also buy brand new connectors for crank sensor from C.Ludwig he is a member here on the forum, i just replaced mine and got them from him.

 

Have several in stock ready to ship. $13 each shipped.

 

The blue connector that isn't used on most FDs (auto trans sensor IIRC) also will plug right in. These tend to be just as crispy as the grey/white CAS connectors, so buying new from Ludwig is probably a better bet. Especially for the CAS, which along with the fuel injectors are about the most important connectors in the engine bay