Connector X-10 and ABS
04-08-06, 06:22 PM
#1
Connector X-10 and ABS
What color is this thing? Where is it at? I see the FSM shows it under the dash somewhere in the drivers side left, but there are alot of connectors down there. Does anyone happen to have a picture of this connector?
Of even more help probably would be for someone to tell me where the drivers side ABS connection wires go after the initial plug in next to the drivers side headlight. The FSM tells me X-10, but I'd like to know more along how the wires run through the harness.
I am having ABS issues, and doing the test on P51 in the FSM tells me that the drivers side front wheel speed sensor isnt giving a signal/not hooked up. I'm pretty sure the sensor is ok, as I didnt have this problem when the last engine was in the car. Any help in tracing this wire from the front driver wheel speed sensor to the ABS comp in the back would be helpful to me.
Thanks
Of even more help probably would be for someone to tell me where the drivers side ABS connection wires go after the initial plug in next to the drivers side headlight. The FSM tells me X-10, but I'd like to know more along how the wires run through the harness.
I am having ABS issues, and doing the test on P51 in the FSM tells me that the drivers side front wheel speed sensor isnt giving a signal/not hooked up. I'm pretty sure the sensor is ok, as I didnt have this problem when the last engine was in the car. Any help in tracing this wire from the front driver wheel speed sensor to the ABS comp in the back would be helpful to me.
Thanks
04-09-06, 12:41 PM
#3
X-10 connector - Blue in color, Located right behind driver side kick panel, Connector contains 10 wires. See pg Z-115 in manual. To Access the connector, remove foot rest pedal, remove scuff plate, remove kick panel, look for the connector.
your welcome
tom
your welcome
tom
04-09-06, 12:45 PM
#4
Of even more help probably would be for someone to tell me where the drivers side ABS connection wires go after the initial plug in next to the drivers side headlight. The FSM tells me X-10, but I'd like to know more along how the wires run through the harness.
These two sensor wires ( white and red shielded ) pass thru X-10 on their way back to the ABS control unit in the rear on the driver side.
These two sensor wires ( white and red shielded ) pass thru X-10 on their way back to the ABS control unit in the rear on the driver side.
04-09-06, 08:06 PM
#5
Thanks for the help. It got me to another step...
I noticed that one of the wires coming from the connector the front drivers ABS wheel speed sensor ends up at the plug for the main engine wiring harness in a large connector with 12 wires going into it. Where does the wire go from there? What is the next connector is goes into? I see only X-10 in the FSM wiring diagram. I have found two connectors now not in that diagram, so its not out of the question to find it go into another 1 before it finally hits X-10. I know it definatly isnt hitting X-10 as I was able to check continuity between it and X-10.
Thanks for any more help.
I noticed that one of the wires coming from the connector the front drivers ABS wheel speed sensor ends up at the plug for the main engine wiring harness in a large connector with 12 wires going into it. Where does the wire go from there? What is the next connector is goes into? I see only X-10 in the FSM wiring diagram. I have found two connectors now not in that diagram, so its not out of the question to find it go into another 1 before it finally hits X-10. I know it definatly isnt hitting X-10 as I was able to check continuity between it and X-10.
Thanks for any more help.
Thread
Thread Starter
Forum
Replies
Last Post