Compression results
#1
Compression results
Hi, I had a compression check done on an fd I might be purchasing soon and these were the results:
rotor 1: 8.0 8.2 8.0
rotor 2: 8.9 8.8 8.7
Now, I searched and read through quite a few threads and these seem to be pretty good numbers, but my question is how consitstant should they be? Is a .6 or .9 difference in the rotors that bad? Thanks in advance for your help.
-Matt McKeever
rotor 1: 8.0 8.2 8.0
rotor 2: 8.9 8.8 8.7
Now, I searched and read through quite a few threads and these seem to be pretty good numbers, but my question is how consitstant should they be? Is a .6 or .9 difference in the rotors that bad? Thanks in advance for your help.
-Matt McKeever
#2
Banned. I got OWNED!!!
Join Date: Jun 2003
Location: Central Florida
Posts: 1,619
Likes: 0
Received 0 Likes
on
0 Posts
Well on each rotor, the compression is close on on 3 faces but with teh 2 rotors so different its kinda concerning.. Youd have to ask one of other members for their opinion but id say that isnt too good with them so different..
#3
These are the specs on Cirian's webpage:
My '93 shop manual says 690 kPa {7.0 kgf/cm2, 100 psi} minimum @ 250 RPM. Differential limit of chambers is 150 kPa {1.5 kgf/cm2, 21 psi} @ 250 RPM.
You are within 1.5 b/w each chamber so according to these specs you are fine.
My '93 shop manual says 690 kPa {7.0 kgf/cm2, 100 psi} minimum @ 250 RPM. Differential limit of chambers is 150 kPa {1.5 kgf/cm2, 21 psi} @ 250 RPM.
You are within 1.5 b/w each chamber so according to these specs you are fine.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM