Coil relocation help
#1
imitek
Thread Starter
Coil relocation help
At the moment i have the coils mounted under intake mani
Not 100% sure if its a good idea
(Heat)
Just wanted to no where els is a good position for coils
http://i1199.photobucket.com/albums/aa474/Imitek/Mobile%20Uploads/20141213_181732.jpg
http://i1199.photobucket.com/albums/aa474/Imitek/Mobile%20Uploads/20141213_181703.jpg
http://i1199.photobucket.com/albums/aa474/Imitek/Mobile%20Uploads/20141213_011932.jpg
http://i1199.photobucket.com/albums/aa474/Imitek/Mobile%20Uploads/20141213_014249.jpg
Not 100% sure if its a good idea
(Heat)
Just wanted to no where els is a good position for coils
http://i1199.photobucket.com/albums/aa474/Imitek/Mobile%20Uploads/20141213_181732.jpg
http://i1199.photobucket.com/albums/aa474/Imitek/Mobile%20Uploads/20141213_181703.jpg
http://i1199.photobucket.com/albums/aa474/Imitek/Mobile%20Uploads/20141213_011932.jpg
http://i1199.photobucket.com/albums/aa474/Imitek/Mobile%20Uploads/20141213_014249.jpg
#2
Senior Member
On the FD, two commonly used locations are left rear of the engine compartment where the cruise control would be, and on the A/C bracket.
You can find pictures and links to suppliers of kits and harnesses on the AEM IGN-1A thread in the 3rd generation specific section
You can find pictures and links to suppliers of kits and harnesses on the AEM IGN-1A thread in the 3rd generation specific section
Thread
Thread Starter
Forum
Replies
Last Post
killerrx710
Adaptronic Engine Mgmt - AUS
5
09-28-15 09:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
09-24-15 10:57 PM