clutch wedged against PP
#1
Rotary Freak
Thread Starter
iTrader: (4)
Join Date: Dec 2003
Location: pembroke, massachusetts
Posts: 2,534
Likes: 0
Received 0 Likes
on
0 Posts
clutch wedged against PP
my clutch when I try to disengage it seems like it jams against the pressure plate, any ideas? its a brand new clutch, just put in. it looks like the clutch is off of the flywheel enough to disengage but it doesnt. The pedal moves to the floor and back without much effort at all. Its a 6 puck spex clutch so im confused as to whats going on.
#4
Rotary Enthusiast
Join Date: Dec 2001
Location: Sunnyvale, CA
Posts: 1,252
Likes: 0
Received 0 Likes
on
0 Posts
YEAA...I got an ACT 6 puck clutch that does the same thing too. After it got stuck to PP, it rubs agains the flywheel, then the flywheel side gone. Then the whole thing stuck together.
6 puck is not good....
6 puck is not good....
#5
Rotary Enthusiast
Join Date: Dec 2001
Location: Sunnyvale, CA
Posts: 1,252
Likes: 0
Received 0 Likes
on
0 Posts
This is gone in about 3 months period. Autocross, track and Drift.
This is my 6 puck clutch at the end:
This is the pressure plate, look nice and smooth.
This is the flywheel side:
This is my 6 puck clutch at the end:
This is the pressure plate, look nice and smooth.
This is the flywheel side:
Thread
Thread Starter
Forum
Replies
Last Post