Hello~ For some reason my clutch isn't working right. There is no sign what-so-ever of slipping and it wasn't popping out of gear when I was driving. Just when I have the car on it refuses to go into gear *I litterally have to push REALLY hard to get it into gears*. It goes into gear fine when the car is off though. My mechanic said he bled the line and nothing... I was thinking the only thing it could be was adjusting the clutch pedal (isn't it right above the pedals)? I am not a mechanic in any way that's why I am asking you guys what you think it is. I don't have the money for a new clutch or for that matter a used one. The mechanic said to buy a new clutch and he'd install it. What should I do because he says to find out if he fixed my turbo problems cause it wasn't kicking in I'd need a new clutch cause he can't get it into gears... do you think I really need a new clutch? Thanks for helping everyone I really appreciate this forum (and YES for all you posters that say use SEARCH I did).
Thanks again.

 

https://www.rx7club.com/forum/showth...hreadid=216301

Start with that. Mods get irritated when the see HELP. don't shoot the messanger.

 

Sorry about the help thing won't do it again. Just looking for some advice. Thanks again.

 

ooooooooo........you wrote help

 

I had the same problem after a clutch/flywheel install. I needed to use a friend's power bleeder to put pressure back into the system.

http://www.focussport.com/pbleed.htm

The system had enough pressure to move through the gears while the car was off, but once it turned on I couldn't get it in gear at all.

Here's what I would try in order:

1. Power bleeder
2. Check clutch line for any leaks
3. Check slave cylinder

 

Thanks Mahjik!