clutch in but found more problems. need advice.
#1
Rotary Enthusiast
Thread Starter
Join Date: Jun 2002
Location: abingdon, maryland
Posts: 1,447
Likes: 0
Received 0 Likes
on
0 Posts
clutch in but found more problems. need advice.
as stated. finally got the clutch in. had to redrop the tranny b/c the stupid throwout bearing wouldn't snap into the pressure plate. anyway got it in and when i was bleeding the clutch there was clutch/brake fluid leaking all over the place as my girl pumped the clutch. when the clutch initially strated to slip i noticed fluid on the garage floor by the bell housing. just thought it was the stupid oil pan which leaked all the time. now i m starting to think that the clutch was slipping b/c of the hydraulic fluid leaking.
what could cause the leakage. too dark to see now . so i will take some suggestions. the **** is leaking out of the lower service window.
could it be the master cylinder?
clutch clyinder ?
busted hydraulic lines?
i will tear into her some more tuesday. oh yeah, on top of all this the tranny won't go into 2nd or reverse. could it be b/c i haven't placed gear oil in the shifter unit? sorry for the long post. but any advice is appreciated. kvn
what could cause the leakage. too dark to see now . so i will take some suggestions. the **** is leaking out of the lower service window.
could it be the master cylinder?
clutch clyinder ?
busted hydraulic lines?
i will tear into her some more tuesday. oh yeah, on top of all this the tranny won't go into 2nd or reverse. could it be b/c i haven't placed gear oil in the shifter unit? sorry for the long post. but any advice is appreciated. kvn
#5
Rotary Enthusiast
iTrader: (5)
Originally Posted by fd3virgin
hey bobby, how are your twins coming along. i will look into getting a new slave cylinder. and see what else is causing this leak. kvn
the manifold is being made right now
and the cage has started
the fab guy works SLOWWWWWWWW
and yea, if you dont put the slav cylinder rod into the clutch fork, you can push the piston out of the slave cylinder and it will leak like a bitch...but if your clutch is working a little bit that is unlikley
Last edited by rfreeman27; 10-17-04 at 07:59 PM.
#6
Rotary Enthusiast
Thread Starter
Join Date: Jun 2002
Location: abingdon, maryland
Posts: 1,447
Likes: 0
Received 0 Likes
on
0 Posts
and yea, if you dont put the slav cylinder rod into the clutch fork, you can push the piston out of the slave cylinder and it will leak like a bitch...but if your clutch is working a little bit that is unlikley[/QUOTE]
let say if you pushed the pison out of the slave cylinder how do you undo it? kvn
let say if you pushed the pison out of the slave cylinder how do you undo it? kvn
Thread
Thread Starter
Forum
Replies
Last Post
83revival
New Member RX-7 Technical
4
09-03-15 10:42 PM