Catalic Convertor / MP / Sensor
#1
Full Member
Thread Starter
Join Date: Feb 2001
Location: Malta
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
Catalic Convertor / MP / Sensor
When replacing the Catalic Convertor with a Mid-Pipe should you put the Sensor which was in the Cat into the MP. This sensor is the one that shows the exhaust overheat warning light.
Thanks in advance for your help.
Thanks in advance for your help.
#2
Senior Member
???
I am pretty sure that the exhaust overheat warning sensor is located in the cockpit under the carpet (on passenger side). You shouldn't have to worry about this when installing a MP.
I am pretty sure that the exhaust overheat warning sensor is located in the cockpit under the carpet (on passenger side). You shouldn't have to worry about this when installing a MP.
#5
Senior Member
You definitely want to replace any ground wires you disconnect from the exhaust system (I think that there is one between the catback and midpipe or converter.
Don't sweat the sensor, leave it in place.
Don't sweat the sensor, leave it in place.
Thread
Thread Starter
Forum
Replies
Last Post
killerrx710
Adaptronic Engine Mgmt - AUS
5
09-28-15 09:13 AM
killerrx710
2nd Generation Specific (1986-1992)
1
09-24-15 10:57 PM
rotor_veux
2nd Generation Specific (1986-1992)
7
09-19-15 07:13 PM