I hope this is the right section for this thread.

OK, so i just got my engine started and cant get it to idle less than 1300+ rpm.

A little about my build.
The engine is a 13B REW port matched to 13B RE cosmo LIM, which is connected to the 13B RE UIM. Its then connected to the REW TB, then to a Rotary works TB elbow.

1. I checked for vaccum leaks, found none.

2. I tried adjusting the Idle control valve screw, nothing

3. I then proceeded to take off the TB elbow to inspect the TB. I noticed a port on the lower left of the TB, covering this was the only way I could lower the Idle.

So I have been searching for solutions on my problem, I came across a thread in one of the many windows that i had opened about welding shut the idle control port on the UIM . Next thing you know it, I accidentally closed the window with the thread.

So is this correct? weld that port off?
Any help would be greatly appreciated.
Sorry for writing a book, I am truly FRUSTRATED.

thanks guys