Cant Dial in my Manual Boost Controller. GAHHH!!!
#1
BOOOYAHHHH!
Thread Starter
Cant Dial in my Manual Boost Controller. GAHHH!!!
I have a Turbo XS HPBC. I adjusted it per instructions and per the instuctions on robs site i hooked it up. But im getting boost creep like no other. Does anyone have the TurboXS HPBC? How did you end up dialing it in? It seems like no matter what settings i set the controller at my primary boost does not change. only my secondary goes nuts. :T... I know i must be doing something wrong... any advice?
#4
BNR built motor and twins
Join Date: May 2003
Location: 2 hours drive from sanity
Posts: 1,235
Likes: 0
Received 1 Like
on
1 Post
I've got the dual stage HPBC. I also had boost creep until I put a cat back on. I was running full non-seq on a ported motor with BNR stage 3's. That included a ported waste gate. I creeped to 15psi no matter what. Now with a mettalic subtrate cat I got it dialed in on 12psi (low) and 15psi (high). Just needed a little back pressure...
#5
BOOOYAHHHH!
Thread Starter
I had no boost creep up untill i installed the Boost controller. I was only able to get 8psi so i added the BC in hopes of getting back that 10... But it is being an uber pain.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM