Boost on primary is different when driven in different gears
08-08-04, 09:40 AM
#1
Rotary Enthusiast
Thread Starter
iTrader: (2)
Join Date: Sep 2002
Location: FL
Posts: 924
Likes: 0
Received 0 Likes
on
0 Posts
Boost on primary is different when driven in different gears
I just recently fixed my boost leak which was the coupling at the intercooler of the y pipe
In first gear i get 8 lbs until 2 takes over
2 gear is about the same
3rd gear i get 12 lbs of boost
and 4 th i get 10-12 lbs
I have intake ,full exhaust, manual boost controller, HKS PFC FCON,9.5 lb flywheel.
Any ideas !
In first gear i get 8 lbs until 2 takes over
2 gear is about the same
3rd gear i get 12 lbs of boost
and 4 th i get 10-12 lbs
I have intake ,full exhaust, manual boost controller, HKS PFC FCON,9.5 lb flywheel.
Any ideas !
08-08-04, 01:17 PM
#4
Rotary Enthusiast
Thread Starter
iTrader: (2)
Join Date: Sep 2002
Location: FL
Posts: 924
Likes: 0
Received 0 Likes
on
0 Posts
LOL yeah! Nice pIc scratchy
I don't understand it, when i floor it in 1st gear boost will go to 8 lbs, then i shift it to 2nd gear it will go to 14 lbs.
But normal driving if i'm in second already rolling, i'll punch it and i'll get 8lbs till 4,500 rpms then i'll get 14 lbs
from a normal acceleration in 3rd, i punch it,i'll get 12 lbs, till 4,500 rpms then 14.
I just need a single turbo !
I don't understand it, when i floor it in 1st gear boost will go to 8 lbs, then i shift it to 2nd gear it will go to 14 lbs.
But normal driving if i'm in second already rolling, i'll punch it and i'll get 8lbs till 4,500 rpms then i'll get 14 lbs
from a normal acceleration in 3rd, i punch it,i'll get 12 lbs, till 4,500 rpms then 14.
I just need a single turbo !
Thread
Thread Starter
Forum
Replies
Last Post
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM