I've been sitting on a set of non seq twins since the summer(being lazy thats all). Anyways, my primary is dead now and Its time to really try and do the swap soon!
Now my question is would the power fc control boost just the same as with stock seq. or would i need to go to a bc?
Anyone have any advise before i go ahead and start the "project"...any parts I should get or might need????

 

for boost control~~ I would get a profec-B.... its much more stable and it works better than the pfc mode~~~

 

The PFC uses the stock solenoids to control boost..if they are in decent shape, the PFC should be ok. I would think the PFC should control non-seq fairly decently.

All you have to do is go into the Commander/Datalogit and change the turbo control to non-sequential.

 

Thanx fellas, I just wanted to make sure. Ultimately I will end up with a Profec B but I doubt i'll have it before the swap.

 

profec b is a waste with non seq twins. read up and use the pfc...it works very well

 

i haven't been able to properly control boost with the PFC in the cold winters on my last 2 FDs. The control system of the 2nd FD, is mostly new and works very well with that exception.