hey guys i went non sequential and followed the diagram with everythin. but if you look in the picture there are to lines on the boost controller and im not sure where that one is going ( the right top one.)

i have a greddy profec B. and on the blakc box it says "in and out" which one of these goes where

thanks alot

 

heres the diagram i used

 

disregard my explination if you had time to read it...just refer to this:

http://www.rx7.org/Robinette/boost_controller.htm

 

ok i get that now my next question. the vaccum line that connects to the back of the boost controller. that needs to go some were to get a reading of pressure. like where the mechanical boost guage would go??

if im way off please let me know

 

where should i put the vaccum line from the turbo. like on the Y-pipe a good spot

if that is a good spot this is what im gonna do

1. from y-pipe to "IN" on stepper motor

2. from "OUT" on stepper motor to wastgate.

3. "T" in the controll box. probally some where in cabin with the boost controller.


thasnk for helping me clarify things. and again if that is totally wrond let me know asap