putting block of plates on 94 because the egr is no good. have the block off kit that comes with about seven other plates. are any of the others worth while to install and will they create any problems? the car is mostly stock few mods

 

Dam that EGR, I got a '92 FD import, god bless the Japs, NO EGR to faff about with!!!

The other plates should be to block off the Double throttle sol on the back of the TB, the air-pump circ system (thats the big one that looks like a fish!!!!hehehe) on the engine side of the LIM, 2x diamond shaped ones for the feed and return on the back side of the LIM, the 2ndry Boost gate on the Y-Pipe(for Non-Seq conversion) and Possibly the 2 AWS removal plates as well.

Depending on the extent of your mods you'll prob not need 90% of them!!! Although depending on how you run your rx you might wana ditch the Double throttle control and if you dont want the cats the big fish, small diamond and offset diamond may come in handy.

Best of luck fella, hope it goes well

 

Huh??

 

Typically, this is what your block-off plate kit should consist of.

http://www.rx7store.net/index.asp?Pa...ROD&ProdID=272

This link should be enough knowledge for the application

http://www.robrobinette.com/turbo_sy...lification.htm

 

You'll get a plate for the IAC...don't use it.

 

^

ISC?

 

Idle Air Control, Idle Speed Control, Anti-Afterburn Control...whatever. Don't block it off.

 

I figured it was just a typo.