Big brakes
#3
Polishing Fiend
iTrader: (139)
Only option that maintains the parking brake:
http://www.negative-camber.org/crispyrx7/rearbrake.htm
David Breslau makes a bracket (if you can get him to actually make any) to fit Wilwood superlites in the back but you will loose the parking brake in the process. It uses the same rotor as the '99 rear brake setup shown above.
And you just missed out on a GB for the Precision rear brake rotors
Other than the obove you want anything you're going to have to start looking too Japan and/or at some pretty expensive custom made setups.
You should also justify the need.
HTH,
Crispy
http://www.negative-camber.org/crispyrx7/rearbrake.htm
David Breslau makes a bracket (if you can get him to actually make any) to fit Wilwood superlites in the back but you will loose the parking brake in the process. It uses the same rotor as the '99 rear brake setup shown above.
And you just missed out on a GB for the Precision rear brake rotors
Other than the obove you want anything you're going to have to start looking too Japan and/or at some pretty expensive custom made setups.
You should also justify the need.
HTH,
Crispy
#4
Lives on the Forum
Join Date: Dec 2001
Location: San Lorenzo, California
Posts: 14,716
Likes: 0
Received 8 Likes
on
8 Posts
The 99-rears use a 12.4-inch rotor with a relocated 93-95 single caliper. $800 for all parts including pads through Mazda Motorsports.
The next step up that I'm aware of is a 4-piston caliper setup by Brembo using 12.6" rotors. You lose the parking brake and they cost $2800 from N-Tech Engineering. http://www.ntechengineering.com/inde...d=6&model_id=2
I don't know about you, but I can buy a lot of things for the $2000 difference.
The next step up that I'm aware of is a 4-piston caliper setup by Brembo using 12.6" rotors. You lose the parking brake and they cost $2800 from N-Tech Engineering. http://www.ntechengineering.com/inde...d=6&model_id=2
I don't know about you, but I can buy a lot of things for the $2000 difference.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
Tem120
3rd Generation Specific (1993-2002)
4
09-07-15 09:53 AM