Auto to Manual coversion Need Help
#1
Senior Member
Thread Starter
Join Date: Sep 2005
Location: cali
Posts: 332
Likes: 0
Received 0 Likes
on
0 Posts
Auto to Manual coversion Need Help
Ok I did the 5 speed conversion, using the Auto harness and 5 speed ECU. I jumped the two white wires on the tranny, and the two Big Red and Blue on the Auto Tranny plug. The car will not start for anything Need Help.
I need to know what wiring i have to do on the Auto harness in order to get the car to Run.
Bryan (916) 832-1758
I need to know what wiring i have to do on the Auto harness in order to get the car to Run.
Bryan (916) 832-1758
#2
Eats, Sleeps, Dreams Rotary
iTrader: (13)
Join Date: Aug 2002
Location: Pittsburg, KS.
Posts: 4,152
Likes: 0
Received 0 Likes
on
0 Posts
I did 2 5 speed swap and I use the 5 speed harness,ecu. This work for me but I don't know about using the AT harness though.
https://www.rx7club.com/showthread.p...06#post2569106
https://www.rx7club.com/showthread.p...06#post2569106
#6
Senior Member
Join Date: Oct 2006
Location: Colorado
Posts: 415
Likes: 0
Received 0 Likes
on
0 Posts
i only jumped the white wires, and the Big RED and BLUE wire on the Tranny plugg
is this the same for S5's?
I'm looking at all the connectors that went to the auto tranny, and I don't see two plain white wires... tried jumping the closest ones, and nothing.
also, don't see a BIG red and blue wire... a couple smaller red and blue ones though...
right now I'm just trying to figure out how to jump the clutch/neutral safety switch thing... I'll worry about the running part after I get the starter to even work.
edit: nevermind, I got it.
Last edited by unicorn_squad; 09-28-07 at 11:58 AM.