Anyone running the APR GTC300 wing and mounts?

Trying to figure out if the holes it uses are the same ones on the outboard of the r1/r2 oem wing.

A bit worried about the holes overlapping and running into issues

 

Call APR. They can adjust the mounts to your spec. With the 300 it's limited due to the curvature but you should be able to match your holes. I have the 250 and they put them exactly where i wanted them.

 

Oh perfect, will reach out and ask. Thanks!

 

I just checked my GTC-300 wing and the R-1-holed hatch I have lying around. While it's close, I don't think they align. The 'longitudinal" distances between the mounts studs on the ARP are 145mm. The longitudinal distance on the R1 wing holes are 130mm. However, I'll defer to Peter's recommendation to check with ARP..

 

NOTE: you can only line up the rear hole anyway. The factory holes aren't parallel, the front holes are wider apart than the rear (at least on my '99 wing), but the wing stansions are parallel, so you will need a second front hole, but the base plate of the APR will cover the other one.