apex seal
#6
Original Gangster/Rotary!
iTrader: (213)
I've been told by a few people that the 3mm seal motors won't last as long... the inner rotor housings must be properly clearanced, and that's not easy to get 100% right. I would only go w/3mm seals if you're planning on running over 20# boost. Otherwise, check out the seals I'm running; there's a website out there which gives alot of good info. I can't remember the address; hopefully someone out there can supply it...
Thread
Thread Starter
Forum
Replies
Last Post
Snook
Single Turbo RX-7's
18
10-08-15 10:09 PM