I have an older blitz controller that I bought recently for little money from a freind who had it in a closet for a while. I hooked it up properly (as far as I know) and wanted to know if anyone else had one of these and could help me figure out if I installed it right (my car engine blew while I was tuning with it but it didnt make my boost go up, but something made my engine go boom ) anyways, I hooked it up between the passenger side nipple of the first turbo and the wastegate actuater, is this correct?( it is just an electronic selonoid that has an in port and an out port). any info on this would be greatly appreciated (pics would be great to if it is convienant. Thanks, you guys are the best-BB

 

^

 

If you get the input and output wrong on the selenoid... you will blow your motor when in boost.... the input is from the turbo side nipple and the out put goes to the far front nipple.
jc sorry no pics...
Set limiter or warning boost first before testing boost.

but try this: blitz power id installation instructions
under this web-site: http://www.mkiv.com/main/index.html

 

sorry try this one instead, lots of info on Rob's old site:
http://www.rx7turboturbo.com/robrobi...controller.htm

jc.