3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Anyone ever use these?

Old Nov 14, 2011 | 01:43 PM
  #1  
goz's Avatar
goz
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Aug 2006
Posts: 340
Likes: 0
From: next door
Anyone ever use these?

dragon racing techometer cluster.

sorry no pics cant find them online. and no cremra with to take pic will upload at a later date.

they worked fine since i imported the seven from japan 6 years ago.

but about 2 years ago the rev counter got a gremlin, it just bounced all over the place intermittently.then some days worked fine.

now after the cars been sitting up in storage for last year or so it works again however.

now.... 1.gas tank reads empty and light stays on.
2.back light worked till i turned on lights now stop workin all together

the oil press and water temp work as good as stock goes!
as ddoes bat light and e break light

iv'e had the clocks out before when rev went but all looked intacked
no smell of circut board or obvious nicks in the circuit wire.and all block connectors pluged in.

possible prob i can think of....
1. ecu need to be reset as batterys been out for that time causing gremlins?
2. clocks are cheap crap and need to be replaced?
3. maybe condinsation on stock ecu as the car was very damp inside.

thanks for any help.
Reply
Old Nov 14, 2011 | 02:12 PM
  #2  
RotaryEvolution's Avatar
Sharp Claws
Tenured Member 15 Years
iTrader: (30)
 
Joined: Oct 2003
Posts: 5,107
Likes: 50
From: Central Florida
check the connectors to the back of the cluster to be sure they are nice and seated.

the fuel gauge and level unit usually go out when someone forgets to install the ground strap to the top of the pump assembly in the hatch area.
Reply
Old Nov 14, 2011 | 03:52 PM
  #3  
goz's Avatar
goz
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Aug 2006
Posts: 340
Likes: 0
From: next door
sound ill look at that tomorrow to make sure and check the earth by pump, as i did the baffels in the tank some years back but am fairly sure i put it back.
maybe il put some connection greese on blocks to make sure theres good connection!
thanks for the reply
Reply


Thread Tools
Search this Thread

All times are GMT -5. The time now is 07:15 AM.