Hey all im VERY new to the forum in fact i dont own and RX7. i am doing a 13b install to a FR car, im VERY fortunate to have my buddy Heath's help and im just wondering while i have the motor out and before i put it in what little things should change/disable/upgrade while it would be easy to do? Also if you have advice on putting a rotary in a previously piston car please feel free to offer it up. The motor is going into a 1985 model so i can be slack on emissions it also weighs a good deal less than the FD so we're hoping its a lil monster.
So far we're planning to:
EGR block off
Take out Double Throttle body
Go non-sequential
Getting all new seals and a fresh rebuild done.
Pretty much everything is from stock used parts that i have acquired, the only thing im sure ill upgrade so far is the intercooler and ill have to go in-line fuel pump due to the car this is all going in.
Also, use the oil metering pump or go premix?
As of right now the motor is in pieces in my garage and pretty much everything is dissassembled what would be good to take care of now before its in the car?
Thanks for reading!

 

If you keep the OMP, use the stainless lines.
New fuel pulsation dampner.
Clean and balance injectors.
If you do emissions delete, some recommend getting a PFC.
New clutch fork, especially if you upgrade your pressure plate. A new pilot and throw-out bearing is probably a good idea.

 

appreciate it man! hadnt thought of those