99 Lip Hole Pattern
#1
99 Lip Hole Pattern
I am working on fitting my urethane bumper and don't currently have a 99 lip. I don't want to do too much fitting without a lip to bring the bottom portions in, also need it for my undertray. I was wondering if anyone has the dimensions, locations of the main attachment points. If not does someone have one that they could measure.
Thanks
Thanks
#2
Banned. I got OWNED!!!
Join Date: Jul 2004
Location: next to the polishing wheel!!!
Posts: 1,179
Likes: 0
Received 1 Like
on
1 Post
No body will be able to lay that out without alot of time and trouble . You need to get one to use or keep and fit it yourself .I did mine and put extra bolts at each end and at the vents .I also made the parts to hold the bolts in place instead of the stock style slip on clips that are threaded in a pressed out hole . If someone kind soul draws it out for you I will be very suprised and if it fits your car also I will be suprised again .I would help you if I could but if I tried to draw it out and your car is different from mine then I would feel bad .If you want to come to TN and take mine off and fit it to yours and drill your holes then return it to my car call me .
#4
rotor rotor pow.
iTrader: (1)
measuring off my standard lip spoiler driverside from lateral to medial
point A 35mm from edge
point B 105mm from center of point A
point C 60mm from center of point B
D 122mm from center of point C
E 152mm "
F 166mm "
G 202mm "
the undertray uses the last 3 points i believe
point A 35mm from edge
point B 105mm from center of point A
point C 60mm from center of point B
D 122mm from center of point C
E 152mm "
F 166mm "
G 202mm "
the undertray uses the last 3 points i believe
#5
When I measure it it appears to be approximately 54 inches from the last hole (nearest the wheel well) to the hole on the other side (nearest the wheel well). I guess I am looking for a straight line distance between the two holes. The measurements that sevensix gave are hole to hole around the lip. I would like to cut a string or brace to bring the two corners of the bumper into their correct location. Which is why I need the distance between the last two holes, passenger side to drivers side.
Thread
Thread Starter
Forum
Replies
Last Post
rotor_veux
2nd Generation Specific (1986-1992)
3
09-28-15 09:25 PM