3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

94 Auto starts, runs, stall on acceleration

Old Aug 6, 2005 | 09:19 AM
  #1  
car hugger's Avatar
Thread Starter
registered user
Tenured Member 15 Years
iTrader: (1)
 
Joined: Mar 2005
Posts: 422
Likes: 0
From: Fort Lauderdale, FL
94 Auto starts, runs, stall on acceleration

First off this 94 Auto was involved in one of the several hurricanes that struck Florida last year. It had been sitting with a blown engine or other problems when the storms came, shattered the glass top and numerous little digs and dents that followed. I'm sure water and rain intruded for a couple days.

The car was taken to a shop where it sat for the better part of 8 months before the motor was torn down and had the gasket set installed. The motor and all parts have been reassembled and the car starts, but not with the ignition.

Problem One. The starter must be jumped at the battery. Then it starts and idles fine, goes into gear and will pull itself as an automatic should until,

Problem Two. On acceleration the car sputters and dies.

As for problem one possible faulty nuetral start switch.

And for problem two, the fuel filter was replaced and found to be dirty.

Thanks in advance.
Reply
Old Aug 6, 2005 | 09:27 AM
  #2  
BigAl65's Avatar
LYSDEXIC
Tenured Member 10 Years
 
Joined: Feb 2001
Posts: 124
Likes: 1
From: Kinston NC
Problem 1) check ignition switch and the small wire connection at the starter.
Problem 2) check both fuel pump relays and the Throttle position sensor...
Allen
Reply
Old Jul 1, 2013 | 09:37 AM
  #3  
rotaryB-2000's Avatar
Psalms 37**25
Tenured Member 10 Years
 
Joined: Jan 2007
Posts: 866
Likes: 0
From: Garnerville N.Y
have a similar issue with a fresh rebuilt automatic..starts fine, accelerate perfect in park but when in gear it does not accelerate....wierd.. any help is appreciated.

this was not an issue pryor to removing the engine..bone stock with no mods.
.
Reply
Old Jul 1, 2013 | 10:58 AM
  #4  
SA3R's Avatar
10-8-10-8
Tenured Member: 10 Years
 
Joined: Jan 2012
Posts: 848
Likes: 12
From: Australia
Weirdly, I had a similar issue with my auto. I hit a kangaroo at 100kmh, and I had to remove the front bumper, radiator, airbox, basically everything up to the engine pulleys depth inwards from the bumper and replace a lot of broken stuff..

First time I fired it up, it refused to idle well. It sounded more like a bridgeport 'brap-brap' idle than a stock car.
Waited til it warmed up, then put it in Drive and sat there, no throttle, foot on brake, and the idle under load in Drive became progressively smoother until it returned to normal. Has been factory-fine ever since. Odd.
Reply
Old Jul 1, 2013 | 11:08 AM
  #5  
Evil_Sephiroth's Avatar
Full Member
iTrader: (1)
 
Joined: Sep 2012
Posts: 195
Likes: 0
From: Lavagna (GE) Italy
Originally Posted by SA3R
Weirdly, I had a similar issue with my auto. I hit a kangaroo at 100kmh, and I had to remove the front bumper, radiator, airbox, basically everything up to the engine pulleys depth inwards from the bumper and replace a lot of broken stuff..

First time I fired it up, it refused to idle well. It sounded more like a bridgeport 'brap-brap' idle than a stock car.
Waited til it warmed up, then put it in Drive and sat there, no throttle, foot on brake, and the idle under load in Drive became progressively smoother until it returned to normal. Has been factory-fine ever since. Odd.
Similar here after fresh rebuild....run fine for 650 KM

Drived slow with no boost for break in (except 3-4 boost around 4500-5000 rpm to try the turbos)

yesterday car suddently stall when i stopped at my house and now it seems a bridgeported engine and stall after 10 second of rough idling or if i push the gas....


If i press gas really really SLOW and i go over 1000 rpm car is fine and i can drive with no power issue all the time I want.....(have to press the gas at the stop to stay over 1000 rpm)
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Kyo
2nd Generation Specific (1986-1992)
6
Apr 13, 2019 09:24 AM
sherff
Adaptronic Engine Mgmt - AUS
9
Feb 24, 2019 12:09 PM
Rotospectre
New Member RX-7 Technical
3
Mar 28, 2018 03:33 PM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
Aug 26, 2015 09:52 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 04:23 PM.