626 MC with Wilwood proportioning valve
01-10-23, 11:41 PM
#1
Make an assessment...
Thread Starter
iTrader: (3)
626 MC with Wilwood proportioning valve
Is anyone using the 626 MC with a Wilwood proportioning valve and have a good place to mount it? Using one of the mounts from Wilwood, it looks somewhat promising, at first.
by https://www.flickr.com/photos/159205146@N07/, on Flickr
It's hard to tell with these pics, but I'm not sure it will fit, on this side at least. I'm going to remove the switch and plug the hole, but even with that I think it will be too long. I could possibly modify the mount to bring it upwards a little, but it might need to be lower to make lines that will work. They have another mount that puts in on the opposite side, but part of the reason I wanted this mount and this valve was because I figured the lines would be pretty direct, having the two ports on the same side.
by https://www.flickr.com/photos/159205146@N07/, on Flickr
by https://www.flickr.com/photos/159205146@N07/, on Flickr
Looking for options.
It's hard to tell with these pics, but I'm not sure it will fit, on this side at least. I'm going to remove the switch and plug the hole, but even with that I think it will be too long. I could possibly modify the mount to bring it upwards a little, but it might need to be lower to make lines that will work. They have another mount that puts in on the opposite side, but part of the reason I wanted this mount and this valve was because I figured the lines would be pretty direct, having the two ports on the same side.
Looking for options.
Thread
Thread Starter
Forum
Replies
Last Post
torresa1
2nd Gen General Discussion
4
11-09-18 12:34 PM