2 quick questions please help
#1
Senior Member
Thread Starter
Join Date: Aug 2006
Location: next door
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
2 quick questions please help
1. i took off thermostat housing bout a month ago ,too tap the housing to add an aftermarket guage. but i got the guage in the states and over hear the taps availible are only metric. so i dont wanna leave the car coolentliss any more as its winter so my question is which way does it go in and what direction does the tab go? newbie question i no but id rather make sure first.
2. what pressure (nm) are the engine dampers at.i no they would range its just my mate has a fue industrial dampers and i might make up some brackets and try it out if specs are good.
thanks for any help p.s i checked owners manual foe question 1
2. what pressure (nm) are the engine dampers at.i no they would range its just my mate has a fue industrial dampers and i might make up some brackets and try it out if specs are good.
thanks for any help p.s i checked owners manual foe question 1
#2
Senior Member
Thread Starter
Join Date: Aug 2006
Location: next door
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
thanks for the speedy reply i think the ones my mate has are 250/300 nm .
also any ideas or pics of thermostat or do u no the direction its to go when being replaced or put back together? thanks again
also any ideas or pics of thermostat or do u no the direction its to go when being replaced or put back together? thanks again
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM