Full Flat Undertray DIY
#1
Junior Member
Thread Starter
Full Flat Undertray DIY
Recently.... I finished an full flat undertray DIY.
to maximize performance of RE-amemiya rear diffuser, it was designed to completely cover bottom of tranny and exhaust lines.
panels were made of aluminum 2.0mm sheet and placed a few NACA duct for cooling.
the yellow front undertray were self-made years ago for c-west aero.
see below pictures. ^^
to maximize performance of RE-amemiya rear diffuser, it was designed to completely cover bottom of tranny and exhaust lines.
panels were made of aluminum 2.0mm sheet and placed a few NACA duct for cooling.
the yellow front undertray were self-made years ago for c-west aero.
see below pictures. ^^
Last edited by Jin-74; 01-27-19 at 05:42 PM.
The following 6 users liked this post by Jin-74:
b3delta (02-21-20),
fzkhan7 (01-28-19),
Gen2n3 (01-29-19),
mr rxeven (02-06-19),
RE-Amemiya (01-30-19),
and 1 others liked this post.
#6
RX-7 Bad Ass
iTrader: (55)
Very nice! That would be a REAL chore to make without a lift!
I've thought about doing something similar, great job there!
Dale
I've thought about doing something similar, great job there!
Dale
Trending Topics
The following users liked this post:
BlackEuropa (07-20-19)
The following users liked this post:
RXyan7 (03-19-20)
#19
Junior Member
Thread Starter
#20
Junior Member
Thread Starter
maybe It will be available in Feb.
thanks~
The following 5 users liked this post by Jin-74:
EZAS (02-07-20),
Montego (02-02-19),
Rocketeerbandit (01-29-19),
the_saint (04-18-21),
wutangben (01-29-19)
#25
Rotary Enthusiast
iTrader: (1)
Just take one guy to put it up at ebay for half the price to ruin the business for the original guy.
Tho, i would buy a template myself for the same reasons you mention.