13b-rew CAD/technical drawings
#51
Racing Rotary Since 1983
iTrader: (6)
10.1 cm from bottom of housing to center of roll pin which appears to be located in the center of the port. maybe it is 10 but on my vernier caliper it shows 10.1
Last edited by Howard Coleman; 07-17-21 at 07:51 PM.
#54
10000 RPM Lane
iTrader: (2)
don’t have a loose 13B-REW engine handy and need some assistance with the vertical dimension between the upper exhaust manifold mounting hole centerline and the lower intake manifold mounting hole centerline
need this to build a jig plate that will let me bolt the intake and exhaust manifolds to it in lieu of an actual engine.
TIA.
.
need this to build a jig plate that will let me bolt the intake and exhaust manifolds to it in lieu of an actual engine.
TIA.
.
#55
Form follows function
iTrader: (8)
don’t have a loose 13B-REW engine handy and need some assistance with the vertical dimension between the upper exhaust manifold mounting hole centerline and the lower intake manifold mounting hole centerline
need this to build a jig plate that will let me bolt the intake and exhaust manifolds to it in lieu of an actual engine.
TIA.
.
need this to build a jig plate that will let me bolt the intake and exhaust manifolds to it in lieu of an actual engine.
TIA.
.
Thread
Thread Starter
Forum
Replies
Last Post