Removing Air Pump
#1
Lawn Ornament
Thread Starter
Removing Air Pump
Ok, anyone have a good walk through, things that needs to be blocked off, taken out, replaced, whatever... Gettin ready to order teh pulley kit and just wondering what else i will need... Thanks
#2
3/4" rubber plug
remove intercooler pipe that crosses between smog pump and alternator
loosen and remove smog pump belt
3 bolts hold the smog pump, take them out
unplug connector
wiggle smog pump out
the pulley replacement should be easy, you just have to loosen the bolts on pulleys you'll be replacing
remove intercooler pipe that crosses between smog pump and alternator
loosen and remove smog pump belt
3 bolts hold the smog pump, take them out
unplug connector
wiggle smog pump out
the pulley replacement should be easy, you just have to loosen the bolts on pulleys you'll be replacing
#3
Lawn Ornament
Thread Starter
Thanks,
i take it you have done this before, do you need air tools to get the other pulleys off, hows the idle, do you use a resistor, how many hoses need to be plugged....
i take it you have done this before, do you need air tools to get the other pulleys off, hows the idle, do you use a resistor, how many hoses need to be plugged....
#4
Lurking..................
Join Date: Mar 2001
Location: PA
Posts: 2,220
Likes: 0
Received 0 Likes
on
0 Posts
check this site out, do all of this, and then add your pulleys.. and of course no need to look for a 30" belt because a belt comes with your pulley set...
http://www.rx7turboturbo.com/robrobinette/air_pump.htm
http://www.rx7turboturbo.com/robrobinette/air_pump.htm
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
12abridgeport
1st Generation Specific (1979-1985)
2
08-17-15 06:28 PM