Belts ate crank trigger wiring
#1
Full Member
Thread Starter
Join Date: Jul 2001
Location: Verona, VA
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Belts ate crank trigger wiring
Here's a good one. Today I went to an autocross with my 7. I made two runs without a problem, then when I started my third run the car just died. Turns out that the wiring for the crank trigger sensors somehow got into the belts on the front of the engine. It completely shredded the wiring.
Anybody else had this happen? I'm a little pissed because I'm guessing that when PFS reinstalled the engine, someone didn't properly route the wiring. Oh well, I'll try to make the best of it and go over everything with a fine tooth comb while I have it apart to fix the wiring.
Anybody else had this happen? I'm a little pissed because I'm guessing that when PFS reinstalled the engine, someone didn't properly route the wiring. Oh well, I'll try to make the best of it and go over everything with a fine tooth comb while I have it apart to fix the wiring.
Thread
Thread Starter
Forum
Replies
Last Post
windom
Adaptronic Engine Mgmt - AUS
4
09-11-15 04:48 AM