Yes or no Vacuum Routing Question (searched)
02-18-09, 01:39 PM
#1
All Blacked Out
Thread Starter
iTrader: (2)
Join Date: Aug 2007
Location: Virginia
Posts: 411
Likes: 0
Received 0 Likes
on
0 Posts
Yes or no Vacuum Routing Question (searched)
To get rid of my cold start problems im installing the Air bypass solenoid valve. my problem is that i have a Jspec Stock Intercooler which only has one nipple instead of two. Since my Jspec only has one nipple can i just use a T nipple fitting thats like a dollar at Autozone and then run both the Air bypass Solenoid Valve & Air supply Valve off one nipple?
02-18-09, 06:50 PM
#6
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
Even with a disabled Air Bypass Solenoid, the BAC should cause the rpms to go to 2000rpm for seventeen seconds. Working with the BAC the figure is a bit higer than 2000 rpm.
Holding the clutch in will disable that feature.
The water temp switch on the bottom of the radiator also effects whether or not the 17 second event happens. Pretty sure about that. LIke it should only happen if the water temp in the radiator is b/t ???? 55*F and 90*F.
Holding the clutch in will disable that feature.
The water temp switch on the bottom of the radiator also effects whether or not the 17 second event happens. Pretty sure about that. LIke it should only happen if the water temp in the radiator is b/t ???? 55*F and 90*F.
Thread
Thread Starter
Forum
Replies
Last Post