YAY!! wait.. crap...
#1
Rotary engine victory
Thread Starter
iTrader: (2)
Join Date: Apr 2004
Location: Newburgh, IN
Posts: 647
Likes: 0
Received 0 Likes
on
0 Posts
YAY!! wait.. crap...
alright today i got the pedal assembly in today and my car is running and i can drive it and YAY!!!!! but anyway i have a question. i put my stearing colum in wrong i gess cuz my stering wheel isnt stright when my car is driving stright. can i just jack my car up and disconnect the stering knuckel and move it to the right spot like that? or do i have to take the entire collum out again to set it stright?
2nd question my clutch pedel is seting up higher than my brake pedel. is there a way i can get them to set at the same highth? or is it supposed to be higher?
thanks for any help
2nd question my clutch pedel is seting up higher than my brake pedel. is there a way i can get them to set at the same highth? or is it supposed to be higher?
thanks for any help
#2
Rotary Enthusiast
Join Date: Oct 2003
Location: Wichita, KS
Posts: 1,183
Likes: 0
Received 0 Likes
on
0 Posts
did you remove the steering wheel for any reason? if not, maybe your toe is just off and it needs an alignment. You can do that by adjusting the tie rods. If you did remove teh steering wheel, maybe you didn't reinstall it correctly. Just pull it off and put it back on again.
Thread
Thread Starter
Forum
Replies
Last Post