Wiring harness question
#26
Just cruising
Thread Starter
Join Date: Oct 2004
Location: Weirton, WV
Posts: 602
Likes: 0
Received 0 Likes
on
0 Posts
It runs but it sure runs bad. The backfiring is gone but I think it is only running on one rotor but the compression is good, its about 90-95 on both rotors. I checked for spark and there is spark on all four plugs (I just pulled the boot off the plugs one at a time and looked for spark).
To fix the problem with the not starting and backfiring, I took off all of the remaining emissions. The only thing left is the BAC. I replaced the spark plug wires, re-connected all of the fittings for the front intercooler tubing and replaced the vacuum hoses that were left. I also replaced a couple of grounds. I replaced the ground that goes from the block to the firewall with 4 ga wire and I added a new 10 ga wire from the block directly to the neg battery terminal plus I cleaned up the ECU ground.
To fix the problem with the not starting and backfiring, I took off all of the remaining emissions. The only thing left is the BAC. I replaced the spark plug wires, re-connected all of the fittings for the front intercooler tubing and replaced the vacuum hoses that were left. I also replaced a couple of grounds. I replaced the ground that goes from the block to the firewall with 4 ga wire and I added a new 10 ga wire from the block directly to the neg battery terminal plus I cleaned up the ECU ground.
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM